USB to Power Cable
USB to mini USB
USA - FCC CFR 47 Part 15, Subpart B This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
* Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio and TV
reception. The user is cautioned that changes and modiﬁcations made to the equipment without
the approval of manufacturer could void the user’s authority to operate this equipment.
Changes or modiﬁcations not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Canada - ICES-003 This Class B digital apparatus complies with Canadian ICES-003. Operation
is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
European RoHS DIR 2002/95/EC
Waste electrical and electronic products must not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority or
Retailer for recycling advice.
©2010 SMK-Link Electronics. SMK-Link, the SMK-Link Logo and PadDock are
trademarks of SMK-Link Electronics, Inc. Apple and iTunes are registered
trademarks of Apple Inc. iPad is a trademark of Apple Inc. “Made for iPad”
means that an electronic accessory has been designed to connect speci-
cally to iPod, iPhone, or iPad, respectively, and has been certied by the
developer to meet Apple performance standards. Apple is not responsible
for the operation of this device or its compliance with safety and regulatory
standards. Please note that the use of this accessory with iPod, iPhone, or
iPad may aect wireless performance. Designed in California by SMK-Link.
Made in Mexico.
Thank you for purchasing PadDock™ 10 from SMK-Link
Electronics. This User’s Guide is designed to help guide
you through setting up your PadDock 10 Stereo Speaker
System for iPad™. The process of setting up your
PadDock 10 is an easy step-by-step process. Should you
need additional help, we have the following resources to
Paddock Specic Website www.pdstand.com
SMK-Link Website www.smklink.com
Toll Free Technical Support 888-696-3500
Free Email Technical Support email@example.com
SMK-Link Electronics, Inc.
3601-B Calle Tecate (805) 987-6662 Oce
Camarillo, CA 93012 (805) 987-6665 Fax
SMK-Link warranties this product against defects in
materials and workmanship under normal use for a
period of one year from the date of purchase. This
warranty only covers SMK-Link hardware. Please save
your receipt as proof of purchase in the unlikely event
that you need warranty service. A full copy of our
warranty statement can be found at