Saris Cycle-On Pro manual

On this page you find the Saris Cycle-On Pro manual. Please read the instructions in this operator manual carefully before using the product. If you have any questions about your that are not answered in the manual, please share your question in the troubleshooting section on the buttom of this page.

Brand
Saris
Model
Cycle-On Pro
Product
Language
English
Filetype
PDF
20" wheel
tray mount
Standard wheel
tray mount
USER MANUAL
CCyyccllee--OOnn PPrroo
Please READ and FOLLOW all instructions carefully.
4017 (1 1/4” RECEIVER) OR 4018 (2” RECEIVER)
ASSEMBLE FRONT WHEEL TRAYS - Determine which holes you
will use to mount the front wheel trays (Fig. 1A). For 20” tires inner-
most holes must be used(20” tire bikes cannot be mounted on the
#4012 add on kit).
Tube
Bolt
Front Wheel
Tray
Washer
Nut
Insert bolt through tube, slide wheel tray on, fasten with washer
and nut (Fig. 1B). Tighten nut until it is snug, where wheel tray
pivots freely. Repeat for each of the 2 front wheel trays.
Next attach the rack to the tilt bracket. Assemble in stepped
order (step 1, 2, 3) as shown above. Tighten knob at end of
bracket until bracket is tight in receiver.
1
2
3
Insert plugs into
unused holes.
1A
1B
2B
MUST use 2 wheel trays per wheel.
See Picture 4B.
Front Wheel
Tray
Washer
Nut
Bolt
Tube
Insert hitch pin and lock into place as shown above. (Note:
Do not stick locking cable through hole, only hitch pin.)
Steel Pin
Pin with
Lanyard
Knob
1
2

Do you have a question about the Saris Cycle-On Pro?

If you have a question about the "Saris Cycle-On Pro", don't hesitate to ask. Make sure to describe your problem clearly, this way other users are able to provide you with the correct answer.

Buy related products:

Related products: