On this page you find the Raikko Cone Bluetooth manual.
Please read the instructions in this operator manual carefully before using the product.
If you have any questions about your that are not answered in the manual, please share your question in the troubleshooting section on the buttom of this page.
Dear Customer, Thank you for choosing a RAIKKO
is a mobile speaker system.
It transmits audio signals through a Bluetooth
(3.5 mm jack) connection.
FPairing / Answer call
G Charging socket
HLine IN socket (3.5 mm)
IUSB charging cable
J 1 line IN cable (3.5 mm jack)
IN THE BOX
Speaker, 1 USB charger cable,
1 line IN cable (3.5 mm jack), 1 carrying pouch
Slide the switch (A) to the right (ON) to turn the speaker on.
Slide the switch (A) to the left (OFF) to turn the speaker off.
The speaker is automatically in Bluetooth
switched on. If a device that has already been connected
is within range, it will connect automatically.
CONNECTION VIA BLUETOOTH
After being switched on, the device will be in “pairing mode”.
Activate the Bluetooth
interface on your audio device (M) and pair
the speaker with it.
If there is a Bluetooth
-enabled device within range that has
already been paired with the speaker, this will be connected rst.
Disconnect this device if required and connect another Bluetooth
For additional information please consult the user manual for your
The maximum range of the wireless signal is 10 m.
Large obstacles, such as furniture, walls and electronic devices,
can limit the range.
It is not possible to pair multiple devices at the same
time. Only one audio device can access the speaker at
any given time.
CONNECTION BY CABLE
To play audio in cable mode, connect the Line IN cable (J) into the
appropriate speaker socket (H).
Connect the other end of the cable to the headphone output on your
audio device (M) or to the audio output on a computer/laptop (N).
Playback via Bluetooth
connection stops automatically
when a cable is inserted. If the cable is removed, playback
may be restarted (if an audio device is
The playback function on the audio device can be controlled
remotely from the speaker if the audio device supports this feature.
Operation using the speaker’s function keys:
Press key (D) once briey to start or stop playback.
Press key (E) once briey to change to the next track.
Press key (C) once briey to restart the current title from the
beginning, or repeatedly to switch to previous tracks.
In cable mode, audio can only be played back (play/pause,
next/previous track) through the connected audio device.
When the speaker is switched on, the volume will be set to a
medium level. The volume can be controlled using the volume
control function on your audio device or directly using the keys on
Hold down the + key (E) to increase the volume.
Hold down the – key (C) to decrease the volume.
It is possible to overload the speakers with a high signal level.
Choose a volume level that will not distort the sound.
The speaker has a built-in microphone. When using a Bluetooth
enabled mobile phone, you can use the speaker-phone function.
To answer a call, press the phone key (F) briey (marked with
a phone symbol). To end a call, press the phone key (F) again
(marked with a phone symbol). Reject calls by holding down the
phone key (F).
CHARGING THE INTEGRATED BATTERY
Charge the speaker completely before using it for the rst time. The
rst charge cycle can take up to 3 hours. Connect the speaker to
the USB port on a PC/MAC™ or a USB mains adapter to charge it.
Use the connection cable (J) provided.
Connect one end to the speaker’s charging socket (Micro USB) (G)
and the other end to the appropriate USB port.
The LED display (K) will turn red while charging.
The LED display (K) will turn off when the battery is fully charged.
A complete charge cycle will last approximately three hours.