On this page you find the dreamGEAR i.Sound Max manual.
Please read the instructions in this operator manual carefully before using the product.
If you have any questions about your that are not answered in the manual, please share your question in the troubleshooting section on the buttom of this page.
PO Box 478
Torrance, CA 90508
• Main Speaker Unit
• Wireless Remote Control
• 3.5mm Audio Cable
i.Sound® MAX Set-up Instructions:
1. When using the i.Sound® MAX Speaker in battery
mode,remove the battery lid located on the
bottom of the main speaker and properly insert
4“AA” batteries as indicated in the battery
compartment. Replace the battery lid.
2. When using a wall-outlet, use the included AC
adapter and plug it into the DC input jack on the
rear of the i.Sound® MAX Speaker System.
Note: only when using the AC adapter, your iPod® will charge
while sitting in the speakers’ base.
Listening to music:
1. Place your iPod
® into the speaker‘s dock. The MAX
Speaker System features different iPod
brackets. These spacers are used for different
models of iPod
®. Choose the proper iPod® spacer
and snap it into the MAX’s docking area. (each
® spacer bracket has the corresponding iPod®
name on it)
2. The i.Sound® MAX is also compatible with iPod
shuffle as well as any other audio device with a
standard headphone jack.
To connect an iPod
® shuffle or other audio device,
connect the included audio cable to your shuffle/audio
player’s headphone jack and than connect the audio
cable to the i.Sound® MAX’s line-in located on the back
of the i.Sound® MAX speaker.
3. Select music from your iPod® and press play.
Adjust the volume to a desired listening level using
the i.Sound® MAX’s volume buttons. (make sure
that your iPod’s® volume is also set to a desirable